In a modify task you take code and adapt it so that it does something else. This time the starter code is not finished: the calculations and the outputs have been left blank, and filling them in is your job.

A running app needs to convert a total number of seconds into minutes and remaining seconds. 130 seconds, for example, is 2 minutes and 10 seconds.

The editor starts you off with this program:

print("Enter total seconds:")
total_seconds = int(input())

full_minutes = 
remaining_seconds = 

print("Minutes: " + str())
print("Seconds: " + str())

Run it as it is and Python stops with a SyntaxError, because an = with nothing after it is not a complete line of code.

Your task

Complete the program so that it:

• calculates the full minutes and stores them in full_minutes,
• calculates the remaining seconds and stores them in remaining_seconds,
• outputs both values, by putting the right variable inside each str().

Choose your operators carefully. An ordinary / gives 130 / 60 = 2.1666666666666665, which is neither the number of whole minutes nor the number of seconds left over. One of the two lines needs the operator that counts whole times, and the other needs the operator that gives what is left over.

Leave the question and the two print lines’ text exactly as they are.

The output

The question, followed by two lines where MINUTES and SECONDS are the two values you calculated:

Enter total seconds:
Minutes: MINUTES
Seconds: SECONDS

Example

Input:

130

Output:

Enter total seconds:
Minutes: 2
Seconds: 10

Input:

3725

Output:

Enter total seconds:
Minutes: 62
Seconds: 5

The minutes are not turned into hours: 3725 seconds is 62 minutes, not 1 hour and 2 minutes.